If you are experiencing these errors above either every time or sporadically when you choose the Load .enb Button, there is a solution available for this until the next EnergyGauge USA update. To do this, you will need to right click on your shortcut for EnergyGauge USA and choose Properties. Once the properties dialogue box opens, choose the Compatibility tab. Once you are on this screen, it should look similar to the screenshot below. At this screen, check the box next to Compatibility mode, and choose one of the XP versions in the list (preferably Service Pack 3 if available). Once this is complete, launch your software and choose the Load .enb button again. If for any reason this does not resolve the issue, please contact Tech Support immediately either by emailing [email protected], or by following this link.
